|
SOLUTIONS:
|
- Oversize, irregular or out-of-round balls. Check the balls using the ball gauge
in the Ball Dams. Discard any balls that do not pass easily through the gauge. Be
sure to rotate the ball inside the hole when testing to check all diameters of the
ball. Use only approved 1-Star, 2-Star, or 3-Star balls. Avoid any balls that have
a rough seam even if they pass the ball gauge test.
- Head angle may be too severe. Reduce angle so head is not all the way up or down.
- Using new balls. New balls have a tacky finish that tends to create excess friction
as the balls move through the robot. As the finish wears down, there is less friction
created. To remove the tacky finish quickly, wash the balls in warm soapy water
and then dry them off before using. Running the balls through the robot at high
speed also helps.
- Dented or cracked balls. Anytime balls jam, check to be sure none of them get dented
or cracked; otherwise, those balls can cause additional jams. Ball denting may also
be caused by build-up of dirt on the Friction Block and/or Ball Discharge Wheel.
Periodically inspect these parts and, if necessary, thoroughly clean with Rubber
Drive Cleaner and a cloth or an all-purpose, water-based cleaner and an old toothbrush.
- Foreign objects or loose parts in the ball feed path. Remove the Front Cover and
inspect for any objects that are preventing the Ball Feed Main Gear from turning
or from balls sliding up the ball feed channel. Also check inside the robot head.
Reattach any loose parts or remove any foreign objects.
- If balls are bridging in the area where the right Ball Return Tray meets the Center
Trough, take two strips of duct tape and tape across the 90 degree angle on the
inside front surface of the Center Trough where the pivoting table mounting mechanism
is attached. When the tape is properly positioned, this 90 degree angle is changed
to approximately 45 degrees, preventing balls from hanging on that corner and causing
a ball bridge to be created.2
- If the problem is with a RP1000, request Newgy to send you two free parts to help
prevent ball jams inside the 1000's Ball Bucket: (1) Ball Feed Gear Blocking Screw
and (2) Ball Feed Stir Spring. These 2 parts are easily installed and greatly reduce
the number of ball jams.1
- Ball Speed Motor runs backward.
See Owner's Manual.
- Worn Ball Discharge Spring. Open the robot head and inspect the back surface of
the Ball Discharge Spring for wear. Replace if any flat shiny surface is found.
This spring should be completely round with no flat spots.
See Owner's Manual.
- Restricted ball feed channel. Occasionally the walls of the ball feed channel may
warp inward enough to keep balls from moving easily upward. Remove the Front Cover
and while holding a known good ball (as tested in A above) slide the ball up and
down the ball feed channel to verify that it does not hang up. If it does, it is
possible to warm the walls with a hair dryer and carefully bend the walls apart
at the restricted area to increase the clearance.
See Owner's Manual.
|